CCD-series are Constant Current Diode Drivers:
CDD is a series of DC/DC diode drivers for CW applications. Compact dimensions, high efficiency and conductive cooling are advantages of this series. It includes several modifications for different output currents and voltages. Custom modifications are available on request.
| INPUT | |||||
|---|---|---|---|---|---|
| Voltage | 24VDC | ||||
| Current | 10A max | ||||
| OUTPUT | |||||
| CDD-10A | CDD-15A | CDD-20A | CDD-25A | ||
| Maximal output current (IMAX) |
10A |
15A |
20A |
25A |
|
| Maximal output voltage (VMAX) |
20V |
13V |
10V |
8V |
|
| Maximal output power | 200 Watts | ||||
| Operational Modes | CW (pulsing capability is limited with rise- and fall-time only) | ||||
| Rise-time/fall-time | < 1 msec | ||||
| Accuracy | < 1% | ||||
| Stability | < 1% | ||||
| INTERFACES | |||||
| Input | AMASS XT30UPB-M | ||||
| Output | M3 thread terminals (2pcs) | ||||
| Controls | MOLEX 90130-1210 | ||||
| Cooling | Conductive cooling through the bottom surface | ||||
| Mechanical | Through holes for M3 screws (2pcs) | ||||
| Environmental | |||||
| Operating temperature | +10…+40oC | ||||
| Storage temperature | -20…+60oC | ||||
| CONTROLS | ||||
|---|---|---|---|---|
|
PIN |
TYPE |
DESIGNATION |
DESCRIPTION |
|
|
1 |
INPUT |
Current Program Jumper | If Pin 1 is connected to Pin 2 with some jumper, output current can be regulated with Current Program potentiometer (R34) placed onboard | |
|
2 |
INPUT |
Current Program | Sets output current (0-5V correspond to 0-IMAX) | |
|
3 |
OUTPUT |
Voltage Monitor | Output signal proportional to the output voltage | |
|
4 |
INPUT |
Current Program Return | Current Program return | |
|
5, 6 |
INPUT |
IDC | Pins 5 and 6 should be interconnected to allow the output | |
|
7 |
OUTPUT |
Current Monitor | Output signal proportional to the output current | |
|
8 |
OUTPUT |
Fault | Failure indication (e.g. Overheat) | |
|
9 |
INP/OUT |
GND | Common ground of all interface signals, except Current Program | |
|
10 |
INPUT | Enable | Enables the output (0V – Enable, 5V or unconnected – disable). A jumper can be set between Pin 9 and 10 to enable the output | |
| MECHANICAL | ||||
|
|
||||
